- Large transmittable peripheral forces – due to the long, flat cones it is possible to transmit maximum torques and axial forces with one RfN 7014 Locking Assembly.
- Maximum reliability – due to the flat cones and the relatively wide construction (large guide lengths) the Locking Assemblies RfN 7014 centre themselves. During installation the Locking Assembly, shaft and hub remain in position to one another. The shaft and hub are loaded by pressure, providing additional safety compared to 3-part versions.
- Heavy pulleys
- Construction of heavy machinery
- Cable sheaves
Mounting of Locking Assembly
The values for T, Fax, pW and pN apply to Locking Assemblies installed in oiled condition.
For shafts and hub bores Ra ≤ 3,2 μm
We recommend the following mounting tolerances
Shaft: k9-h9; Hub: N9-H9
Arrangement of several Locking Assemblies RfN 7014
Two Locking Assemblies at most can be installed in series. In this case the transmission values of the above table are doubled.
Change of screw tightening torques
A reduction of the contact pressures and the transmission values by reducing the tightening torque of the screws is possible. The admissible lower limit results from the multiplication of the TA values of the above table by 0,8. There is an approximate linear relationship between T, TA, Fax, pW and pN.